Built, confirming to British standard BS 4074: 1982 and tested to BS 5507 Part 3: 1982, of high grade steel, these Props can be used for a multitude of purposes where an adjustable load bearing element is required.

Coarse adjustments are possible utilising the heavy duty pin through the slot in the outer tube and the holes (@ regular intervals) in the inner tube. Finer adjustments are achieved through the rolled thread on the cast iron collar.

HEAVY DUTY PROP

Made of 3.2mm inner and 3.2mm outer tube they are available in five standard sizes offering extensions from 1.07m to 4.87m

MEDIUM DUTY PROP

A 2.0mm inner and 2.0mm outer tybe is used to make the medium duty Prop.

• Props must always be loaded concentrically and be plumb.
• SWLs allow not more than 1.5 Deg. Out-of-plumb loaded concentrically.
• Any extension attachment bolted to the Prop must be considered in height when using the table.
• It should be ensured that the Prop always rests on the safest axis and loaded concentrically.